3 new burglar-resistant electronic measures are now available for the Pivot door:
These can also be combined with each other (P+R+G).
Example with P+R+G:
Position monitoring (P) / (P2)
This alarm component is used to monitor the position of the Pivot door.
The magnetic contact and the disk magnet are pre-installed in the frame profile and the door profile in the upper,
lock-side corner of the door to be secured. The magnetic contact is kept closed by the magnetic field of the permanent magnet.
→ The Pivot door is then considered closed.
If the distance between the two parts is increased (door leaf open), the influence of the magnetic field is weakened. The magnetic contact then opens and interrupts the closed circuit.
→ The Pivot door is then considered open.
Deadbolt monitoring (R)
All locking profiles (shutters) can be equipped with a deadbolt monitor.
When the mortise lock is closed, the deadbolt (R) is extended, which actuates a concealed switch contact built into the frame profile that closes the circuit.
→ The Pivot door is then considered locked.
Glass breakage monitoring (G)
Sky-Frame Pivot is available with alarm glasses.
The screen printed metal circuit is protected in the gap between the panes on surface position 2 and is always positioned in the top corner on the lock side.
In the event of an attack with subsequent destruction of the outer pane of glass (TSG), it disintegrates into a large number of small fragments. This also interrupts the conductive screen printed metal circuit in several locations, causing the electrical circuit to be interrupted. This is detected by the connected burglar alarm (EMZ), and an alarm is triggered.
Further information:
Detailed information can be found in the following document:
The new Pivot Guard (P,R,G) feature can now be ordered on request. It is not yet available for selection in the Webshop.